Flange Sprayguards
Flange sprayguards are used to protect personnel from uncontrolled spray out from a failing flange joint. They should always be considered when installing any piping system carrying toxic or corrosive chemicals. By controlling the leak and protecting personnel and surrounding plant equipment from chemical contact considerable cost savings can be made. They help to minimise accidents on plant preventing costly plant down time, unplanned absenteeism, HSE investigations etc.
The CRP range of Sprayguards has been designed to be very cost effective, manufactured from hardwearing polypropylene they have very good chemical resistance, are UV resistant and can be reused.
Very easy to install, they are supplied as a roll, the correct length is cut from the roll and then wrapped around the flange joint, they are secured with a stainless steel self tapping screw.
If a spray out were to occur the spray is safely deflected diminishing the force of the spray.
The spray out is deflected not contained so the guard is never pressurised.
Three widths of Spray Guard will cover most piping installations
The Spray Guards are suitable for use on piping ranging from -40oC to +110oC.
Available in 25 metre rollsThe CRP Spray Guard is available in 5 roll widths, 50mm, 70mm, 100mm, 140mm and 180 mm to cover flange joint sizes from ½” up to 24” nominal bore. Typically only 2 or 3 widths can cover most installations on site.
The table below shows the correct width required for typical flange joints and the cut length of sprayguard required for each flange nominal bore. 
All data shown for ASME 150 flanges.